Balboa Bath Pumps circ. HA350 / 0.55kW/0.7HP

Direction for use

Electrical supply 220-240VAC 50Hz.
The pumps must be installed in a place, where there is easy access to the terminal box.
If the cable is replaced, the square dimension of the cable must not be reduced.
The cables must be of a minimum type H05VV-F fully connected to earth.
Ensure that the cable gland is fully tightened.
The pump must be protected by a fuse.
In order to separate the pump from the mains there has to be installed a suitable ground fault circuit interrupter with at least 3 mm break distance on each terminal in the present electrical installation. External earth screw on the motor to be used for connection of external equipotential bonding.

Attention!!

1. The pumps must not be used for liquids in excess of 60°C.

2. It is recommended to connect other types than DRP (Dry Run Protection) pumps via an electronic

   control box that has a detection device fitted to detect the absence of liquid.

3. The installation must be according to the normal power indicated on the label.

4. It is recommended that you consult a state-registered electrician.

5. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly

   qualified persons in order to avoid a hazard.

6. Locate the pump in a dry area with good ventilation.

7. The ambient temperature must not exceed 40°C.

8. The pumps are solely for use in whirlpool and spa systems.

9. This appliance is not intended for use by persons, including children with reduced physical, sensory or

   mental capabilities or lack of experience and knowledge, unless they have been given supervision or

   instruction concerning use of the appliance by a responsible for their safety.

10. Children should be supervised to ensure that they do not play with the appliance.

Functional description for DRP pumps

Press the pneumatic button, and keep the pressure a few seconds to ensure the pump builds up the needed water pressure, and then let go off the button again. As long as pressure is present, the pump will run until the next press on the pneumatic button. This will turn it OFF again. If the water pressure drops (or if there is no water in the system) the pump will stop automatically. If the pump has been stopped automatically, it will need re-setting before it will function properly again. This is done by shortly pressing the pneumatic button.

Mounting of pump

There are different ways of installing the pump:

1. The easily accessible rubber feet allow quick installation of the pump, by screwing 4 pcs. of M6 bolts up into the nuts, that are integrated in the rubber feet.

2. With a mounting plate, you simply screw one M10 bolt or a threaded pole up into the nut that is integrated in the plate, and the pump is in place.